How to change ur IP

The following is a guide on how to change your IP in 30 seconds or
less. This can be used if your IP has been banned from a game server,
or on gunbound if your IP get's blocked. I've tried this on both
Windows XP and Windows 2000, and it has worked!


1. Click on "Start" in the bottom left hand corner of screen

2. Click on "Run"

3. Type in "command" and hit okay

You should now be at an MSDOS prompt screen.

4. Type "ipconfig /release" just like that, and hit "enter"

5. Type "exit" and leave the prompt

6. Right-click on "Network Places" or "My Network Places" on your desktop.

7. Click on "properties"

* You should now be on a screen with something titled "Local Area
Connection", or something close to that, and, if you have a network
hooked up, all of your other networks. *

8. Right click on "Local Area Connection" and click "properties"

9. Double-click on the "Internet Protocol (TCP/IP)" from the list under the "General" tab

10. Click on "Use the following IP address" under the "General" tab

11. Create an IP address (It doesn't matter what it is. I just type 1
and 2 until i fill the area up. I use my same ip address with a
different number at end of ip, same sub mask, same default gateway.)

12. Press "Tab" and it should automatically fill in the "Subnet Mask" section with default numbers.

13. Hit the "okay" button here

14. Hit the "okay" button again

*You should now be back to the "Local Area Connection" screen.*

15. Right-click back on "Local Area Connection" and go to properties again.

16. Go back to the "TCP/IP" settings

17. This time, select "Obtain an IP address automatically"

18. Hit "okay"

19. Hit "okay" again

20. You now have a new IP address

With a little practice, you can easily get this process down to 15 seconds.


*Note* This only changes your dynamic IP address, not your ISP/IP
address. If you plan on hacking a website with this trick be extremely
careful, because if they try a little, they can trace it back

--------------------------------------------------------------------

CLik start

1-run >>>> cmd>>> ipconfig/release

2-go to control pannel >>> network connection>> local irea connection
chose ip/tcp and press properity

3
-chose use the following ip address

4-type 111.111.111.111 then press tab

5-press ok


-------------------------------------------------------------------------------

This is step by step ( changin ip for window vista ) how to change TCP and IP settings: Go to the Control Panel from the Start menu. Click "Network and Internet" and then "Network and Sharing Center." Click "Manage network connections." Choose which Internet connection you would like to change if you have more than one. Right click on it and select "Properties." Click the "Networking" tab. Choose either Internet Protocol Version 4 (TCP/IPv4) or Internet Protocol Version 6 (TCP/IPv6). Click "Obtain an IP Address Automatically" to reset your IP address automatically, then click OK. Click "Use the following IP Address" to enter your own IP settings. Enter your IP address into the boxes marked "IP Address," "Subnet Mask" (or "Subnet prefix length for IP/TCPv6) and "Default gateway." How to change DNS server settings: Click "Obtain DNS Server Address Automatically" and then click "OK." Click "Use the following DNS Server addresses" to change your DNS Server settings manually. Type your primary DNS Server address into the box that says "Preferred DNS Server." Type your secondary DNS Server address into the box that says "Alternate DNS Server." How to add a new network protocol: Click "Properties" and then "Install" from "Manage network connections." Click "Client," "Service" or "Protocol," depending on which you wish to add. Then click "Add." Select the item you want to add from the dialogue box and click "OK"